EX35 RWD V6-3.5L (VQ35HR) (2008)
Crankshaft Main Bearing Seal: Service and Repair
REAR OIL SEAL
REAR OIL SEAL: Removal and Installation
REMOVAL
1. Remove transmission assembly.
2. Remove drive plate.
3. Remove rear oil seal with a suitable tool.
CAUTION:
Be careful not to damage crankshaft and cylinder block.
INSTALLATION
1. Install rear oil seal.
^
Install rear oil seal so that each seal lip is oriented as shown in the figure.
A: Oil seal lip
B: Dust seal lip
<---: Engine inside
<---: Engine outside
^
Press in rear oil seal (1) to the position as shown in the figure.
B: Cylinder block rear end face
a: 0 - 0.5 mm (0 - 0.020 in)