EX35 RWD V6-3.5L (VQ35HR) (2008)
/Page-438002.png)
EM-50 Exploded View (Part 2)
REMOVAL
1. Release the fuel pressure.
2. Disconnect the battery cable from the negative terminal.
3. Remove engine cover with power tool.
4. Remove radiator reservoir tank.
5. Remove air duct and air cleaner case assembly (RH and LH).
6. Remove engine undercover with power tool.
7. Drain engine coolant from radiator.
CAUTION:
^
Perform this step when the engine is cold.
^
Never spill engine coolant on drive belt.
8. Remove radiator hose (upper and lower).
9. Drain engine oil.
CAUTION:
^
Perform this step when the engine is cold.
^
Never spill engine oil on drive belt.
10. Remove drive belt.
11. Remove radiator cooling fan assembly.
12. Separate engine harnesses removing their brackets from front timing chain case.
13. Remove intake manifold collector.
14. Remove intake manifold.
15. Remove fuel sub tube mounting bolt.
16. Remove oil level gauge and oil level gauge guide.
17. Remove A/C compressor from bracket with piping connected, and temporarily secure it aside.
18. Remove power steering oil pump from bracket with piping connected, and temporarily secure it aside.
19. Remove power steering oil pump bracket.
20. Remove idler pulley, auto tensioner and bracket.
21. Remove alternator and alternator bracket.
22. Remove water outlet (front) and water piping.
23. Remove valve timing control covers (bank 1 and bank 2) and gasket as follows:
a. Disconnect valve timing control harness connector.
