EX35 RWD V6-3.5L (VQ35HR) (2008)
^ Lightly check to see if the switch rotates loosely. If the switch rotates loosely, the pin is damaged. This bulletin applies. Proceed to step 3.
^ If the switch is not loose and does not rotate, this bulletin does not apply. Return to ASIST for further diagnostic assistance.
NOTE:
Switch is shown removed for illustrative purpose.
3. Remove parking brake adjusting nut located at the top of the parking brake assembly.
CAUTION:
Do NOT reuse adjusting nut after replacing PEDAL. Replace adjusting nut with a new one listed in Parts Information.
NOTE:
The parking brake cables DO NOT need to be removed for this procedure.
4. Disconnect parking brake switch harness connector.