EX35 RWD V6-3.5L (VQ35HR) (2008)
1. Apply liquid gasket to the position shown in the figure with the following procedure:
A: Liquid gasket application point
F: View
I: End surface of camshaft bracket (No. 1)
b: 4 mm (0.16 in)
c: [diameter]2.5 - 3.5 mm (0.098 - 0.138 in)
d: 5 mm (0.20 in)
g: 10 mm (0.39 in)
<---: Engine front
Use Genuine RTV silicone sealant or equivalent.
a. Refer to figure (E) to apply liquid gasket to joint part of camshaft bracket (No. 1) (1) and cylinder head.
b. Refer to figure: to apply liquid gasket in 90° to figure.
2. Install rocker cover gasket to rocker cover.
3. Install rocker cover.
^
Check if rocker cover gasket is not dropped from the installation groove of rocker cover.
4. Tighten bolts in two steps separately in numerical order as shown in the figure.
<---: Engine front
1st step 2.0 Nm (0.2 kg-m, 18 in-lb)