EX35 RWD V6-3.5L (VQ35HR) (2008)
b. Use a feeler gauge, measure the clearance between valve lifter and camshaft.
Valve clearance: Refer to EM-140, "Camshaft". See: Engine, Cooling and Exhaust/Engine/Camshaft, Lifters and Push
Rods/Camshaft/Specifications/Service Limits and General Specifications
^
By referring to the figure, measure the valve clearances at locations marked "x" as shown in the table below (locations indicated in the
figure).
<---: Engine front
^
No. 1 cylinder at compression TDC
c. Rotate crankshaft 240° clockwise (when viewed from engine front) to align No. 3 cylinder at TDC its compression stroke.
NOTE: