EX35 RWD V6-3.5L (VQ35HR) (2008)
Air Bag Control Module: Service and Repair
DIAGNOSIS SENSOR UNIT
Exploded View
SR-16 Exploded View
Removal and Installation
WARNING:
-
Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes.
-
Before disconnecting the air bag diagnosis sensor unit harness connectors, be sure to disconnect the each harness connector of the air bag
module and seat belt pre-tensioner to prevent air bag deployment by static electricity and seat belt pre-tensioner operation.
-
Do not use air tools or electric tools for servicing.
REMOVAL
1. Disconnect each connector of all air bag modules and pre-tensioner seat belts.
2. Remove the center console assembly.
3. Disconnect diagnosis sensor unit harness connector.
4. Remove the fixing bolts, ground bolt, and then remove diagnosis sensor unit.
CAUTION:
-
Replace the air bag diagnosis sensor unit if it has been dropped or sustained an impact.
-
Replace the air bag diagnosis sensor unit of deployed SRS air bag and deployed front seat belt pre-tensioner.
INSTALLATION