EX35 RWD V6-3.5L (VQ35HR) (2008)
/Page-1093009.png)
21. Adjust inner socket to standard length (L), and then tighten lock nut to the specified torque. Check length again after tightening lock nut.
Standard
L: Refer to ST-54, "Inner Socket Length". See: Tie Rod/Specifications/Inner Socket Length
CAUTION: Adjust toe-in after this procedure. The length achieved after toe-in adjustment is not necessary the above value.
2WD: Inspection
INSPECTION AFTER INSTALLATION
^
Check if steering wheel turns smoothly when it is turned several times fully to the end of the left and right.
^
Check the steering wheel play, neutral position steering wheel, steering wheel turning force, and front wheel turning angle. Refer to ST-13,
"Inspection". See: Testing and Inspection/Component Tests and General Diagnostics/Steering Wheel
^
Check the fluid level, fluid leakage, and air bleeding hydraulic system. Refer to ST-11, "Inspection". See: Testing and Inspection/Symptom
Related Diagnostic Procedures/Power Steering Fluid Inspection
INSPECTION AFTER DISASSEMBLY
Boot
Check boot for cracks, and replace it if a malfunction is detected.
Rack Assembly
Check rack for damage or wear, and replace it if a malfunction is detected.
Gear-Sub Assembly
^
Check gear-sub assembly for damage or wear, and replace it if a malfunction is detected.
^
Rotate gear-sub assembly and check for torque variation or rattle, and replace it if a malfunction is detected.
Gear Housing Assembly
Check gear housing assembly for damage and scratches (inner wall). Replace if there are.
Outer Socket and Inner Socket
Check the following items and replace the component if it does not meet the standard.
BALL JOINT SWINGING TORQUE
Hook a spring balance at the point shown in the figure and pull the spring balance. Make sure that the spring balance reads the specified value when
ball stud and inner socket start to move. Replace outer socket and inner socket if they are outside the standard.
Standard
(Measuring point of outer socket: Stud cotter pin mounting hole)
