EX35 RWD V6-3.5L (VQ35HR) (2008)
/Page-756005.png)
22. Disconnect TCM connectors (A) and (B)
CAUTION: Be careful not to damage connectors.
23. Remove A/T assembly harness connector (A) from control valve with TCM using flat-blade screwdriver (B)
24. Disconnect TCM connector (A) and park/neutral position switch connector (B)
CAUTION: Be careful not to damage connectors.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
^
Be careful not to damage connector when installing any connector.
^
Do not reuse drain plug gasket.
^
Do not reuse O-ring.
^
Apply ATF to O-ring.
^
Adjust bolt hole of bracket to bolt hole of control valve with TCM when installing A/T fluid temperature sensor 2 (with bracket).
^
Refer to the followings when installing control valve with TCM in transmission case.
CAUTION:
