EX35 RWD V6-3.5L (VQ35HR) (2008)
^
Make sure that turbine revolution sensor securely installs turbine revolution sensor hole (B).
A: Brake band
^
Hang down revolution sensor harness toward outside so as not to disturb installation of control valve with TCM.
^
Adjust A/T assembly harness connector of control valve with TCM to terminal hole of transmission case.
^
Assemble it so that manual valve (1) cutout is engaged with manual plate (2) projection.
-
Install bolts (A), (B) and (C) in control valve with TCM. Tighten bolt 1, 2 and 3 temporarily to prevent dislocation. After that tighten them in
order (1 ---> 2 ---> 3), and then tighten other bolts. Tighten control valve with TCM bolts to the specified torque.
<---: Vehicle front