FX35 RWD V6-3.5L (VQ35DE) (2003)
4. Remove the thread suspended to the left side of board and suspend a thread with weight on tip on the center of the target board.Then mark the
point of weight on the ground.
5. Pivot the edge of the target board 20° to either side.
NOTE: Approx. 50 mm (1.97 in) shift rates the 20° movement.
6. Do not place anything in the space shown in the figure (view from top).
NOTE: In case the space shown in the illustration is not available, make space by covering the side of the target board with a 400 mm (15.75 in)
size frosted black board or black cloth.
Aiming Adjustment
CAUTION:
-
Complete all necessary work for laser beam adjustment until the adjustment completes as shown in the procedure. If the procedure does not
complete, the ICC system is inoperable.
-
If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on
control unit which carry out CAN communication.
1. Turn ignition switch OFF.