FX35 RWD V6-3.5L (VQ35DE) (2003)
NOTE: Turning the screw to the right lowers the aiming and to the left lifts the aiming.
9. When "U/D CORRECT" value indicates ±4, confirm that the margin of value remains within ±4 at least for 2 seconds with no equipment or hand
touching the ICC sensor. When "COMPLETED THE VERTICAL AIMING OF LASER BEAM" appears on screen, touch "END".
CAUTION: Be sure that the margin of "U/D CORRECT" is within ±4 with ICC sensor unit is untouched.
10. Confirm that "ADJUSTING AUTOMATIC HORIZONTAL LASER BEAM AIMING" is on screen and wait for a while (maximum: 10 seconds).
11. Confirm that "NORMALLY COMPLETED" is displayed on CONSULT-II and close the aiming adjustment procedure by touching "END".
CAUTION: Complete all the procedures once "LASER BEAM ADJUST" mode is entered in CONSULT-II. When the procedure is
discontinued, the ICC system is inoperable.
CHECK AFTER THE ADJUSTMENT
Test the ICC system operation by running test. Refer to "ICC System Running Test" . See: Testing and Inspection/Component Tests and General
Diagnostics/Diagnostic Strategies/Action Test/Vehicle-to-Vehicle Distance Control Mode