FX35 RWD V6-3.5L (VQ35DE) (2003)
Fuel Gauge Sender: Service and Repair
Disassembly and Assembly
CAUTION: Sub fuel level sensor unit cannot be disassembled and should be replaced as a unit.
DISASSEMBLY
Remove fuel level sensor unit with the following procedure.
1. Disconnect harness connector.
-
Hold connector by fingers and pull it out, because there is no stopper release tab.
2. Using a suitable tool, pull up tabs as shown in the figure (2 points) to release the lock.
CAUTION: Be careful not to damage it.