FX35 RWD V6-3.5L (VQ35DE) (2003)
7. Remove low-pressure pipe (VK45DE).
INSTALLATION
Installation is basically the reverse order of removal.
CAUTION:
-
Replace O-rings for A/C piping with new one, then apply compressor oil to it when installing it.
-
Connection point for female-side piping is thin. So, when inserting male-side piping, take care not to deform female-side piping. Slowly insert in
axial direction.
-
Insert one-touch joint connection point securely until it clicks.
-
After piping has been connected, pull male-side piping by hand to check that piping does not come off.
-
When recharging refrigerant, check for leaks.
Bolt mounting the low-pressure flexible hose bracket
Tightening torque : 5.5 Nm (0.56 kg-m, 49 in-lb)
Removal and Installation of High-pressure Flexible Hose
REMOVAL
1. Use a refrigerant collecting equipment (for HFC-134a) to discharge the refrigerant.
2. Remove the air cleaner and air duct.
3. Remove mounting bolt for high-pressure flexible hose bracket.
4. Disconnect one-touch joint between high-pressure flexible hose and condenser.
a. Set a disconnector (92530-89912) on A/C piping.
b. Slide a disconnector upward until it clicks.