FX35 RWD V6-3.5L (VQ35HR) (2010)
1. Disengage the pawls from the body side panel with remover tool
(A).
2. Remove rear kicking plate outer (1).
Triangle : Pawl
CENTER PILLAR LOWER GARNISH
1. Remove front and rear kicking plate inner.
2. Insert a remover tool (A) between center pillar lower garnish (1) and body side panel to disengage the clips and pawls.
3. Remove center pillar lower garnish.
Circle : Clip
Triangle : Pawl
CENTER PILLAR UPPER GARNISH
1. Remove the front seat belt anchor floor bolt. See: Restraint Systems/Seat Belt Systems/Seat Belt Buckle/Service and Repair/Front Seat
Belt/Exploded View.
2. Remove front and rear kicking plate inner.
3. Remove center pillar lower garnish.
4. Remove center pillar upper garnish lower clip.
5. Hold the upper side of center pillar upper garnish (1), then remove it as shown in the figure below.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
When installing body side trim, check that clips are securely fitted in panel holes on body, and then press them in.