FX35 RWD V6-3.5L (VQ35HR) (2010)
Power Mirror Switch: Testing and Inspection
Door Mirror Remote Control Switch
Component Function Check
DOOR MIRROR REMOTE CONTROL SWITCH
CHANGEOVER SWITCH : Component Function Check
1.CHECK CHANGEOVER SWITCH FUNCTION
Check the operation on "MIR CHNG SW-R" or "MIR CHNG SW-L" in "DATA MONITOR" mode using CONSULT-III.
Is the inspection result normal?
YES - Changeover switch function is OK.
NO - See: Memory Positioning Systems/Testing and Inspection/Component Tests and General Diagnostics/Door Mirror Remote Control
Switch/Changeover Switch/Diagnosis Procedure.
Diagnosis Procedure
DOOR MIRROR REMOTE CONTROL SWITCH
CHANGEOVER SWITCH : Description
Changeover switch is integrated into door mirror remote control switch.
Changeover switch has three positions (L, N and R).
It changes door mirror motor operation by transmitting control signal to automatic drive positioner control unit.
DOOR MIRROR REMOTE CONTROL SWITCH
CHANGEOVER SWITCH : Diagnosis Procedure
1.CHECK CHANGEOVER SWITCH INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect door mirror remote control switch connector.
3. Turn ignition switch ON.
4. Check voltage between door mirror remote control switch harness connector and ground.
Is the inspection result normal?
YES - GO TO 3.
NO - GO TO 2.
2.CHECK CHANGEOVER SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit connector.
3. Check continuity between automatic drive positioner control unit harness connector and door mirror remote control switch harness connector.