FX35 RWD V6-3.5L (VQ35HR) (2010)
-
When replacing brake pad with new one, check a brake fluid level in the reservoir tank because brake fluid returns to master cylinder
reservoir tank when pressing piston in.
NOTE:
Use a disc brake piston tool to easily press piston.
5. Install the lower sliding pin bolt and tighten it to the specified torque.
6. Depress the brake pedal several times to check that no drag feel is present for the front disc brake. See: Procedures/Front Disc Brake/Brake Pad (2
Piston Type).
Exploded View
FRONT DISC BRAKE
BRAKE PAD (2 PISTON TYPE) BRAKE PAD (2 PISTON TYPE) : Exploded View
Removal and Installation
FRONT DISC BRAKE
BRAKE PAD (4 PISTON TYPE) : Removal and Installation
REMOVAL
WARNING:
Clean any dust from the brake caliper and brake pads with a vacuum dust collector. Never blow with compressed air.
CAUTION:
-
Never depress the brake pedal while removing the brake pads because the piston may pop out.
-
Never spill or splash brake fluid on the disc rotor and caliper.
1. Remove tires with power tool.