FX35 RWD V6-3.5L (VQ35HR) (2010)
DISASSEMBLY
Removal and Installation
REAR DISC BRAKE
BRAKE CALIPER ASSEMBLY (2 PISTON TYPE) : Removal and Installation
REMOVAL
WARNING:
Clean any dust from the brake caliper and brake pads with a vacuum dust collector. Never blow with compressed air.
CAUTION:
Never depress the brake pedal. Brake fluid may splash while removing the brake hose and brake tube.
1. Remove tires with power tool.
2. Fix the disc rotor using wheel nuts.
3. Drain brake fluid. See: Brake Fluid/Service and Repair/Draining.
CAUTION:
Never spill or splash brake fluid on the disc rotor.
4. Loosen the flare nut with a flare nut wrench and separate the brake tube from caliper.
CAUTION:
-
Cover flare nut wrench with a cloth as not to damage the caliper.
-
Never scratch the flare nut and the brake tube.
-
Never bend sharply, twist or strongly pull out the brake tube.
-
Cover open end of brake tube when disconnecting to prevent entrance of dirt.
5. Remove brake hose mounting bolt.