FX35 RWD V6-3.5L (VQ35HR) (2010)
system operation.
Air Tight
-
Idle the engine for 1 minute to apply vacuum to the brake booster, and stop the engine. Then depress the brake pedal several times at 5-second
intervals until the accumulated vacuum is released to atmospheric pressure. Check that the clearance between brake pedal and dash lower panel
gradually increases (A to B to C) each time the brake pedal is depressed when performing this operation.
-
Depress the brake pedal with the engine running. Then stop the engine while holding down the brake pedal. Check that the brake pedal stroke does
not change after holding down the brake pedal for 30 seconds or more.
NOTE:
A slight impact with a small click may be felt on the pedal when the brake pedal is fully depressed. This is a normal phenomenon due to the brake
system operation.
ADJUSTMENT AFTER INSTALLATION
Perform the brake pedal adjustment after installing the brake pedal assembly. See: Brake Pedal Assy/Service and Repair/Inspection and Adjustment.
Exploded View
VACUUM LINES
Exploded View
VQ35HR