FX35 RWD V6-3.5L (VQ35HR) (2010)
Wheel Speed Sensor: Service and Repair
Rear Wheel Sensor
Exploded View
WHEEL SENSOR
REAR WHEEL SENSOR : Exploded View
Removal and Installation
WHEEL SENSOR
REAR WHEEL SENSOR : Removal and Installation
REMOVAL
Be careful with the following when removing sensor.
-
Never twist sensor harness as much as possible, when removing it. Pull sensors out without pulling sensor harness.
-
Be careful to avoid damaging sensor edges or rotor teeth. Remove wheel sensor first before removing front or rear wheel hub. This is to avoid
damage to sensor wiring and loss of sensor function.
INSTALLATION
Be careful with the following when installing wheel sensor. Tighten installation bolts to the specified torques. See: Exploded View.
-
When installing, make sure there is no foreign material such as iron chips on and in the mounting hole of the wheel sensor. Make sure no foreign
material has been caught in the sensor rotor. Remove any foreign material and clean the mount.
-
When installing a rear LH wheel sensor, be sure to pass the wheel sensor harness under the breather hose.