FX35 RWD V6-3.5L (VQ35HR) (2010)
Engine Oil: Service and Repair
Inspection
ENGINE OIL
Inspection
ENGINE OIL LEVEL
NOTE:
Before starting engine, put vehicle horizontally and check the engine oil level. If engine is already started, stop it and allow 10 minutes before
checking.
1. Pull out oil level gauge and wipe it clean.
2. Insert oil level gauge and check the engine oil level is within the range (A) shown in the figure.
3. If it is out of range, adjust it.
NOTE:
When checking the engine oil level, insert oil level gauge (1) with its tip aligned with oil level gauge guide.
2 : Engine cover
White arrow : Engine front
ENGINE OIL APPEARANCE
-
Check engine oil for white turbidity or heavy contamination.
-
If engine oil becomes turbid and white, it is highly probable that it is contaminated with engine coolant.
Repair or replace damaged parts.
ENGINE OIL LEAKAGE
Check for engine oil leakage around the following areas:
-
Oil pans (lower and upper)
-
Oil pan drain plug
-
Oil pressure switch
-
Oil temperature sensor
-
Oil filter
-
Oil filter bracket (AWD models)
-
Valve timing control cover
-
Mating surface between cylinder head and rocker cover
-
Mating surface between front timing chain case and rear timing chain case
-
Mating surface between rear timing chain case and cylinder head
-
Mating surface between rear timing chain case and cylinder block