FX35 RWD V6-3.5L (VQ35HR) (2010)
Air Door Actuator / Motor: Service and Repair
Air Mix Door Motor
DOOR MOTOR
AIR MIX DOOR MOTOR : Removal and Installation
REMOVAL
Driver Side
1. Set the temperature (driver side) at 18.0°C (60°F).
2. Disconnect the battery cable from the negative terminal.
3. Remove instrument lower panel LH. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Exploded
View.
4. Remove automatic drive positioner control unit. See: Accessories and Optional Equipment/Memory Positioning Systems/Memory Positioning
Module/Service and Repair/Exploded View.
5. Remove mounting screws (A), and then remove air mix door motor (driver side) (1).
6. Disconnect air mix door motor connector.
Passenger Side
1. Set the temperature (passenger side) at 18°C (60°F).
2. Disconnect the battery cable from the negative terminal.
3. Remove blower unit. See: Blower Motor/Service and Repair/Blower Unit/Exploded View (VQ35HR) or See: Blower Motor/Service and
Repair/Blower Unit/Exploded View (VK50VE).
4. Remove mounting screws (A), and then remove air mix door motor (passenger side) (1).
5. Disconnect air mix door motor connector.
INSTALLATION
Installation is basically the reverse order of removal.