infiniti Workshop Repair Guides

Infiniti Workshop Service and Repair Manuals

Fuel Level Sensor > < Additional Service When Replacing Control Unit|Page 2412
Page 3
background image

-

When steady-state driving is performed again even after it is interrupted, each diagnosis can be conducted.

In this case, the time required for diagnosis may be extended.
Pattern 3:

-

Operate vehicle following the driving pattern shown in the figure.

-

Release the accelerator pedal during deceleration of vehicle speed from 90 km/h (56 MPH) to 0 km/h (0 MPH).

Pattern 4:
-

The accelerator pedal must be held very steady during steady-state driving.

-

If the accelerator pedal is moved, the test must be conducted again.

*1: Depress the accelerator pedal until vehicle speed is 90 km/h (56
MPH), then release the accelerator pedal and keep it released for more than 10 seconds. Depress the accelerator pedal until vehicle speed is 90 km/h
(56 MPH)
 again.
*2: Checking the vehicle speed with GST is advised.

Suggested Transmission Gear Position for A/T Models
Set the selector lever position in the D with the overdrive switch turned ON.

Fuel Level Sensor > < Additional Service When Replacing Control Unit|Page 2412