FX35 RWD V6-3.5L (VQ35HR) (2010)
/Page-716158.png)
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the accelerator pedal actuator for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal?
YES - GO TO 2.
NO - Repair the terminal and connector.
2.CHECK HARNESS FOR OPEN CIRCUIT
1. Disconnect the connector of accelerator pedal actuator.
2. Check the resistance between the accelerator pedal actuator harness connector terminals.
Is the measurement value within the specification?
YES - GO TO 3.
NO - Repair the accelerator pedal actuator branch line.
3.CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the accelerator pedal actuator. See: Cruise Control/Testing and Inspection/Component Tests and
General Diagnostics/Power Supply and Ground Circuit/Accelerator Pedal Actuator.
Is the inspection result normal?
YES (Present error)-Replace the accelerator pedal actuator. See: Fuel Delivery and Air Induction/Accelerator Pedal/Service and Repair/With
Distance Control Assist System/Exploded View See: Fuel Delivery and Air Induction/Accelerator Pedal/Service and Repair/With Distance Control
Assist System/Removal and Installation, "MODELS WITH DISTANCE
CONTROL ASSIST SYSTEM : Exploded View".
YES (Past error)-Error was detected in the accelerator pedal actuator branch line.
NO - Repair the power supply and the ground circuit.
CAN System (Type 6)
APA BRANCH LINE CIRCUIT
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the accelerator pedal actuator for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal?
YES - GO TO 2.
NO - Repair the terminal and connector.
2.CHECK HARNESS FOR OPEN CIRCUIT
1. Disconnect the connector of accelerator pedal actuator.
2. Check the resistance between the accelerator pedal actuator harness connector terminals.
Is the measurement value within the specification?
YES - GO TO 3.
NO - Repair the accelerator pedal actuator branch line.
3.CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the accelerator pedal actuator. See: Cruise Control/Testing and Inspection/Component Tests and
General Diagnostics/Power Supply and Ground Circuit/Accelerator Pedal Actuator.
Is the inspection result normal?
YES (Present error)-Replace the accelerator pedal actuator. See: Fuel Delivery and Air Induction/Accelerator Pedal/Service and Repair/With
Distance Control Assist System/Exploded View See: Fuel Delivery and Air Induction/Accelerator Pedal/Service and Repair/With Distance Control
