FX35 RWD V6-3.5L (VQ35HR) (2010)
11. Remove fuel injector (2) from fuel tube (4) as per the following:
3 : O-ring
A : Installed condition
B : Clip mounting groove
a. Open and remove clip (1).
b. Remove fuel injector from fuel tube by pulling straight.
CAUTION:
-
Be careful with remaining fuel that may go out from fuel tube.
-
Be careful not to damage injector nozzles during removal.
-
Never bump or drop fuel injector.
-
Never disassemble fuel injector.
12. Remove fuel sub-tube and fuel damper, if necessary.
INSTALLATION
1. Install fuel damper (4) as per the following:
a. Install new O-ring (2) to fuel tube (1) as shown. When handling new O-ring, be careful of the following caution:
CAUTION:
-
Handle O-ring with bare hands. Never wear gloves.
-
Lubricate O-ring with new engine oil.
-
Never clean O-ring with solvent.
-
Check that O-ring and its mating part are free of foreign material.
-
When installing O-ring, be careful not to scratch it with tool or fingernails. Also be careful not to twist or stretch
O-ring. If O-ring was stretched while it was being attached, never insert it quickly into fuel tube.
-
Insert new O-ring straight into fuel tube. Never twist it.
b. Install spacer (3) to fuel damper.
c. Insert fuel damper straight into fuel tube.