FX35 RWD V6-3.5L (VQ35HR) (2010)
/Page-797004.png)
CAUTION:
-
Insert straight, checking sure that the axis is lined up.
-
Insert fuel damper at 130 N (13.3 kg, 29.2 lb) or less to prevent damage to the parts.
-
Insert fuel damper until (B) is touching (A) of fuel tube.
d. Tighten bolts evenly in turn.
-
After tightening bolts, check that there is no gap between fuel damper cap (5) and fuel tube.
2. Install fuel sub-tube.
-
When handling new O-rings, be careful of the following caution:
CAUTION:
-
Handle O-ring with bare hands. Never wear gloves.
-
Lubricate O-ring with new engine oil.
-
Never clean O-ring with solvent.
-
Check that O-ring and its mating part are free of foreign material.
-
When installing O-ring, be careful not to scratch it with tool or fingernails. Also be careful not to twist or stretch O-ring. If O-ring was
stretched while it was being attached, never insert it quickly into fuel tube.
-
Insert new O-ring straight into fuel tube. Never decenter or twist it.
-
Insert fuel sub-tube straight into fuel tube.
-
Tighten mounting bolts evenly in turn.
-
After tightening mounting bolts, check that there is no gap between flange and fuel tube.
3. Install new O-rings to fuel injector, paying attention to the following.
CAUTION:
-
Upper and lower O-ring are different. Be careful not to confuse them.
Fuel tube side : Black
Nozzle side : Green
· Handle O-ring with bare hands. Never wear gloves.
· Lubricate O-ring with new engine oil.
· Never clean O-ring with solvent.
· Check that O-ring and its mating part are free of foreign material.
· When installing O-ring, be careful not to scratch it with tool or fingernails. Also be careful not to twist or stretch O-ring. If O-ring was
stretched while it was being attached, never insert it quickly into fuel tube.
-
Insert O-ring straight into fuel injector. Never decenter or twist it.
4. Install fuel injector to fuel tube as per the following:
a. Insert clip (3) into clip mounting groove (D) on fuel injector (5).
2 : O-ring (Black)
4 : O-ring (Green)
