FX35 RWD V6-3.5L (VQ35HR) (2010)
Accelerator Pedal Position Sensor: Service and Repair
Without Distance Control Assist System
Exploded View
ACCELERATOR CONTROL SYSTEM
MODELS WITHOUT DISTANCE CONTROL ASSIST SYSTEM : Exploded View
Removal and Installation
ACCELERATOR CONTROL SYSTEM
MODELS WITHOUT DISTANCE CONTROL ASSIST SYSTEM : Removal and Installation
REMOVAL
1. Remove the bolt cap and the inside mounting bolt.
2. Remove accelerator pedal assembly.
3. Disconnect accelerator pedal position sensor harness connector.
CAUTION:
-
Never disassemble accelerator lever. Never remove accelerator pedal position sensor from accelerator lever.
-
Avoid impact from dropping etc. during handling.
-
Be careful to keep accelerator lever away from water.
INSTALLATION
Installation is the reverse order of removal.
Inspection
ACCELERATOR CONTROL SYSTEM
MODELS WITHOUT DISTANCE CONTROL ASSIST SYSTEM : Inspection
INSPECTION AFTER INSTALLATION
-
Check accelerator pedal moves smoothly within the whole operation range when it is fully depressed and released.
-
Check accelerator pedal securely returns to the fully released position.
-
For the electrical inspection of accelerator pedal position sensor, See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/P Code Charts/P2122, See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/P Code Charts/P2127, and See: Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/P Code Charts/P2138 (VQ35HR) or , , and EC-1083, "Description" (VK50VE).