FX35 RWD V6-3.5L (VQ35HR) (2010)
Mark a position 240 degrees (b) from a corner of the hexagonal part of crankshaft pulley mounting bolt as shown in the figure.
Use the hexagonal part as a guide.
1 : Crankshaft pulley
A : Paint mark
-
By referring to the figure, measure the valve clearances at locations marked "×" as shown in the table below (locations indicated in the figure).
White arrow : Engine front
-
No. 5 cylinder at compression TDC
3. Perform adjustment if the measured value is out of the standard. Refer to "ADJUSTMENT".
ADJUSTMENT
-
Perform adjustment depending on selected head thickness of valve lifter.
1. Measure the valve clearance. Refer to "INSPECTION".
2. Remove camshaft. See: Engine, Cooling and Exhaust/Engine/Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal and
Replacement/Removal and Installation.
3. Remove valve lifters at the locations that are out of the standard.