FX35 RWD V6-3.5L (VQ35HR) (2010)
Perform the calibration and perform the writing to the around view monitor control unit when removing and replacing each camera,
removing the camera mounting parts (front grille, door mirror, etc.) and replacing the around view monitor control unit.
Navigation (Twin Monitor)
AROUND VIEW MONITOR CONTROL UNIT
Removal and Installation
REMOVAL
1. Remove front seat (LH side). See: Body and Frame/Seats/Service and Repair/Front Seat/Exploded View.
2. Remove floor carpet. Keep a service area.
3. Remove around view monitor control unit mounting screws.
4. Disconnect connector and remove around view monitor control unit.
INSTALLATION
1. Installation is the reverse order of removal.
2. Perform camera image calibration. See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Programming and Relearning/Calibrating Camera Image (Around View Monitor)/Work Procedure/Navigation (Twin Monitor).
3. Perform predictive course line center position adjustment. See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist
Systems/Testing and Inspection/Programming and Relearning/Predictive Course Line Center Position Adjustment/Work Procedure/Navigation
(Twin Monitor).
CAUTION:
Perform the calibration and perform the writing to the around view monitor control unit when removing and replacing each camera,
removing the camera mounting parts (front grille, door mirror, etc.) and replacing the around view monitor control unit.