FX35 RWD V6-3.5L (VQ35HR) (2010)
Is the inspection result normal?
YES - GO TO 10.
NO - Repair or replace damaged parts.
10.CHECK HARNESS BETWEEN FUSE BLOCK (J/B) AND STOP LAMP SWITCH (PART 2)
Check continuity between fuse block (J/B) vehicle side harness connector terminal and ground.
Is the inspection result normal?
YES - GO TO 11.
NO - Repair or replace damaged parts.
11.DETECT MALFUNCTIONING ITEM
Check the following.
-
Harness for short or open between ignition switch and fuse block (J/B). .
-
Ignition switch
-
10A fuse [No.3, located in the fuse block (J/B)]. See: Maintenance/Fuses and Circuit Breakers/Fuse Block/Diagrams.
-
Fuse block (J/B)
Is the inspection result normal?
YES - Check intermittent incident. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Intermittent Incident.
NO - Repair or replace damaged parts.
12. CHECK INSTALLATION POSITION OF STOP LAMP SWITCH
Adjust stop lamp switch position. See: Brakes and Traction Control/Brake Pedal Assy/Service and Repair/Inspection and Adjustment.
- GO TO 13.
13.CHECK STOP LAMP SWITCH (PART 2)
Check stop lamp switch. See: Component Inspection (Stop Lamp Switch).
Is the inspection result normal?
YES - INSPECTION END
NO - Replace stop lamp switch. See: Brakes and Traction Control/Brake Pedal Assy/Service and Repair/Exploded View.
Component Inspection (Shift Lock Solenoid)
SHIFT LOCK SYSTEM
Component Inspection (Shift Lock Solenoid)
1.CHECK SHIFT LOCK SOLENOID
Apply voltage to terminals 3 and 4 of shift lock unit connector, and then check that shift lock solenoid is activated.
CAUTION:
Connect the fuse between the terminals when applying the voltage.
Can the lock plate be moved up and down?
YES - INSPECTION END
NO - Replace shift lock unit. See: Shifter A/T/Service and Repair/7AT RE7R01B/A/T Shift Selector/Exploded View.
Component Inspection (Stop Lamp Switch)