FX35 RWD V6-3.5L (VQ35HR) (2010)
Transmission Cooler: Removal and Replacement
Exploded View
FLUID COOLER SYSTEM
2WD 2WD : Exploded View
Removal and Installation
FLUID COOLER SYSTEM
2WD : Removal and Installation
REMOVAL
1. Remove air duct (inlet). See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Air Cleaner
Fresh Air Duct/Hose/Service and Repair/Exploded View.
2. Remove engine lower cover with power tool. See: Body and Frame/Interior Moulding / Trim/Service and Repair/Floor Side Fairing/Exploded
View.
3. Remove A/T fluid cooler hose A and A/T fluid cooler hose B.
4. Remove A/T fluid cooler tubes from A/T assembly and engine.
5. Plug up opening such as the A/T fluid cooler tube hole.
6. Remove A/T fluid cooler tubes from the vehicle.
CAUTION:
Be careful not to bend A/T fluid cooler tubes.
7. Remove clips and bracket.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
Never reuse copper washer.