FX45 AWD V8-4.5L (VK45DE) (2006)
4. Remove the thread suspended to the left side of board and suspend a thread with weight on tip on the center of the target board. Then mark the
point of weight on the ground.
5. Pivot the edge of the target board 20 degrees to either side.
NOTE: Approx. 50 mm (1.97 in) shift rates the 20 degrees movement.
6. Do not place anything in the space shown in the figure (view from top).
NOTE: In case the space shown in the figure is not available, make space by covering the side of the target board with a 400 mm (15.75 in)-size
frosted black board or black cloth.
Aiming Adjustment
CAUTION: Complete all necessary work for laser beam adjustment until the adjustment completes as shown in the procedure. If the procedure does not
complete, the ICC system is inoperable.
NOTE: CONSULT-II basic operation: Refer to GI-38, "CONSULT-II Start Procedure". See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes
1. Touch "WORK SUPPORT".