FX45 AWD V8-4.5L (VK45DE) (2006)
Fuel Gauge Sender: Service and Repair
Disassembly and Assembly
Components
Disassembly and Assembly
CAUTION: Sub fuel level sensor unit cannot be disassembled and should be replaced as a unit.
DISASSEMBLY
Remove fuel level sensor unit as follows.
1. Disconnect harness connector.
-
Hold connector by fingers and pull it out, because there is no stopper release tab.
2. Using suitable tool, pull up tabs points as shown in the figure (two points) to release the lock.
CAUTION: Be careful not to damage it.