FX45 AWD V8-4.5L (VK45DE) (2006)
Accelerator Pedal Position Sensor: Service and Repair
ACCELERATOR CONTROL SYSTEM
Components
Removal and Installation
REMOVAL
1. Disconnect accelerator pedal position sensor harness connector.
2. Loosen mounting nuts, and remove accelerator pedal assembly.
CAUTION:
-
Do not disassemble accelerator pedal assembly. Do not remove accelerator pedal position sensor from accelerator pedal assembly.
-
Avoid impact from dropping etc. during handling.
-
Be careful to keep accelerator pedal assembly away from water.
INSTALLATION
Installation is the reverse order of removal.
INSPECTION AFTER INSTALLATION
-
Make sure accelerator pedal moves smoothly within the whole operation range when it is fully depressed and released.
-
Make sure accelerator pedal securely returns to the fully released position.
-
For the electrical inspection of accelerator pedal position sensor, refer to the following.
-
VQ35DE
"DTC P2122, P2123 APP SENSOR", "DTC P2127, P2128 APP SENSOR" and "DTC P2138 APP SENSOR".
-
VK45DE
"DTC P2122, P2123 APP SENSOR", "DTC P2127, P2128 APP SENSOR" and "DTC P2138 APP SENSOR".
CAUTION: When harness connector of accelerator pedal position sensor is disconnected, perform "Accelerator Pedal Released Position
Learning". Refer to EC-84, "Accelerator Pedal Released Position Learning" (VQ35DE) or EC-743, "Accelerator Pedal Released Position
Learning" (VK45DE). See: Computers and Control Systems/Testing and Inspection/Programming and Relearning/Accelerator Pedal Released
Position Learning