FX45 AWD V8-4.5L (VK45DE) (2006)
2. Touch "LASER BEAM ADJUST".
3. Touch "START".
CAUTION: If the adjustment screen does not appear on the CONSULT-II screen in 10 seconds. After touching "LASER BEAM ADJUST"
screen, the following causes may be considered:
-
Target is not set accurately.
-
There is not enough space beside the target.
-
Deformation of vehicle or the surrounding equipment unit, bracket, or the surrounding equipment is causing inappropriate installation of
sensor and aiming may be set out of the adjustable range.
-
The area is not suitable for the adjustment work.
-
ICC sensor is not clean.
4. After the CONSULT-II displays "ADJUST THE VERTICAL OF LASER BEAM AIMING" turn the up-down direction adjusting screw until
"U/D CORRECT" value is set in the range of ±4.