FX50 AWD V8-5.0L (VK50VE) (2009)
and Repair/Back Door Finisher/Exploded View.
3. Remove rear camera mounting screws and rear camera harness connector.
4. Remove rear camera.
INSTALLATION
1. Installation is the reverse order of removal.
2. Perform camera image calibration. Refer to See: Testing and Inspection/Programming and Relearning/Calibrating Camera Image (Around View
Monitor)/Description/Navigation (Single Monitor) See: Testing and Inspection/Programming and Relearning/Calibrating Camera Image (Around
View Monitor)/Special Repair Requirement/Navigation (Single Monitor), "CALIBRATING CAMERA IMAGE (AROUND VIEW MONITOR) :
Special Repair Requirement".
CAUTION:
Perform the calibration and perform the writing to the around view monitor control unit when removing and replacing each camera,
removing the camera mounting parts (front grille, door mirror, etc.) and replacing the around view monitor control unit.
Navigation (Twin Monitor)
REAR CAMERA
Removal and Installation
REMOVAL
1. Remove back door outside finisher upper. Refer to See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim
Panel/Service and Repair/Back Door Finisher/Exploded View.
2. Remove door handle cover. Refer to See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim Panel/Service
and Repair/Back Door Finisher/Exploded View.
3. Remove rear camera mounting screws and rear camera harness connector.
4. Remove rear camera.
INSTALLATION
1. Installation is the reverse order of removal.
2. Perform camera image calibration. Refer to See: Testing and Inspection/Programming and Relearning/Calibrating Camera Image (Around View
Monitor)/Description/Navigation (Twin Monitor) See: Testing and Inspection/Programming and Relearning/Calibrating Camera Image (Around
View Monitor)/Special Repair Requirement/Navigation (Twin Monitor), "CALIBRATING CAMERA IMAGE (AROUND VIEW MONITOR) :
Special Repair Requirement".
CAUTION:
Perform the calibration and perform the writing to the around view monitor control unit when removing and replacing each camera,
removing the camera mounting parts (front grille, door mirror, etc.) and replacing the around view monitor control unit.