FX50 AWD V8-5.0L (VK50VE) (2009)
6. Insert a remover tool (A) between the door finisher (1) and door panel to disengage the clips.
CAUTION:
Insert a remover tool into the part show in the figure.
(Between the clips and the door panel)
7. Disconnect lock knob cable (1) and inside handle cable (2) from rear inside handle (3).
8. Remove the mood lamp harness connector. Refer to See: Lighting and Horns/Courtesy Lamp/Service and Repair/Mood Lamp/Rear Door
Armrest/Exploded View.
9. Disconnect the rear door power window switch harness connector.
10. Remove the rear door finisher.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
When installing door finisher, check that clips are securely fitted in panel holes on body, and then press them in.