FX50 AWD V8-5.0L (VK50VE) (2009)
Cowl Moulding / Trim: Service and Repair
Removal and Installation
COWL TOP
Removal and Installation
REMOVAL
1. Fully open hood assembly.
2. Remove front wiper arms and blades (LH/RH) from vehicle. Refer to See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Front
Wiper Arm and Blade/Removal and Installation.
3. Remove battery cover and brake master cylinder cover.
4. Remove cowl top cover seals (LH/RH).
5. Remove hoodledge cover mounting clips and then remove hoodledge covers (LH/RH).
6. Remove front fender covers (1) fixing clips (LH/RH).
7. Remove cowl top seal.
8. Remove cowl top covers (LH/RH) fixing clips.
9. Push pawls (A) and (B) to remove cowl top cover RH (1) as shown in the figure.
10. Push pawl (A) as shown by the arrow in the figure to remove cowl top cover LH (1).
INSTALLATION
Note the following items, and install in the reverse order of removal.
-
Align concave of cowl top cover RH (1) to windshield glass (2) pin