FX50 AWD V8-5.0L (VK50VE) (2009)
d. Install new VVEL actuator sub assembly.
-
Tighten mounting bolts in the following step, in numerical order as shown.
CAUTION:
-
When installing, be careful with VVEL actuator sub assembly (bank 1) mounting bolt No. 4 because its length is different.
-
Be sure to check that the VVEL actuator sub assembly is in contact with the cylinder head before tightening the mounting bolts.
e. Remove holding jig.
f.
Check that VVEL actuator arm bolt hole is aligned with control shaft tapped hole. If it is not aligned, turn control shaft for alignment.
CAUTION:
Never give an impact to the magnet part. (A)