FX50 AWD V8-5.0L (VK50VE) (2009)
a. Set No. 1 cylinder at TDC of its compression stroke.
-
Rotate crankshaft pulley clockwise to align timing mark
(grooved line without color) (B) with timing indicator (A).
-
Check that exhaust cam nose on No. 1 cylinder (engine front side of bank 1) is located as shown in the figure.
-
If not, turn crankshaft one revolution (360 degrees) and align as shown in the figure.
-
By referring to the figure, measure the valve clearances at locations marked "×" as shown in the table below (locations indicated in the figure).