FX50 AWD V8-5.0L (VK50VE) (2009)
B. Compare the Part Number you wrote down to the numbers in the Current ECM Part Number column in Table A above.
^
If there is a match this bulletin applies. Continue with the reprogramming procedure.
NOTE:
If there are two lines (two reprogramming options) on your C-III screen use the one that does not have the message "Caution! Use ONLY with
ITBXX-XXX".
^
If there is not a match, this bulletin does not apply. Close C-III and refer to ASIST for further diagnostic information.
3. If this bulletin applies and you have performed ECM reprogramming the screen in Figure 2 appears when reprogramming is complete.
NOTE:
If the screen in Figure 2 does not display (reprogramming does not complete).
4. Make sure to erase DTCs from all Systems.
NOTE:
During the reprogramming DTCs will set in several systems. DTCs must be erased from all systems.