FX50 AWD V8-5.0L (VK50VE) (2009)
Impact Sensor: Service and Repair
Side Air Bag (Satellite) Sensor
Removal and Installation
SIDE AIR BAG (SATELLITE) SENSOR
Removal and Installation
WARNING:
-
Before servicing, turn ignition switch OFF, disconnect the battery negative terminal and wait at least
3 minutes.
-
Never use the air tools or the electric tools for servicing.
REMOVAL
1. Remove the front seat belt retractor. Refer to See: Seat Belt Systems/Seat Belt Retractor/Service and Repair/Front Seat Belt/Removal and
Installation.
2. Remove the satellite sensor (1) fixing nuts (B).
3. Disconnect the harness connector (A), and then remove the satellite sensor.
CAUTION:
-
Replace the satellite sensor of deployed the SRS front side air bag module and deployed the SRS side curtain air bag module.
-
Never impact the satellite sensor.
-
Replace the satellite sensor if it has been dropped or sustained an impact.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Never use the old fixing nuts after removal; replace with the new nuts.
-
Never damage the harness while installing.
-
If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using
self-diagnosis or CONSULT-III.
-
After the work is completed, check that no system malfunction is detected by air bag warning lamp. Refer to See: Air Bag
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnosis System (Airbag)/Diagnosis Description.
Exploded View
SIDE AIR BAG (SATELLITE) SENSOR