FX50 AWD V8-5.0L (VK50VE) (2009)
14. Remove the bolt shown in Figure 22.
^ This is the pinch bolt that secures the tilt motor.
15. Move the center support bearing out of its bore as follows:
a. Place a flat blade screw driver at the point shown in Figure 23.
b. Push / pry the tilt motor towards the steering wheel.
c. Push the tilt motor enough to force the center support bearing about 1/2 inch towards the steering wheel.
NOTE:
If the center support bearing moves up and down while moving the steering wheel up and down, it is out of its bore.