FX50 AWD V8-5.0L (VK50VE) (2009)
c. Disconnect the electrical connector.
d. Cut the tie-wrap.
e. Use pliers to break the plastic electrical connector off of the old motor so it will be unusable.
Install New Tilt and Telescope Motors
17. Apply a moderate amount of "TILT" grease to the spines on the tilt motor shaft as shown.
^ Do not use the entire tube of grease. Use only the amount needed.
^ The "TILT" grease is included in the Motor Assy - Tilt kit (see Parts Information).
18. Connect the electrical connector to the new tilt motor.
19. Install the new tilt motor as follows:
a. Push up on the steering wheel.
b. Put the motor in mounting position.