FX50 AWD V8-5.0L (VK50VE) (2009)
Removal and Installation
SIDE OIL SEAL
LEFT SIDE : Removal and Installation
REMOVAL
1. Remove the front final drive assembly from vehicle with power tool.
NOTE:
Left side oil seal is attached to engine assembly. Replace it after removing front final drive assembly from vehicle.
2. Remove the side oil seal using a flat-bladed screwdriver.
CAUTION:
Never damage gear carrier.
INSTALLATION
1. Apply multi-purpose grease to sealing lips of side oil seal.
2. Using the drift (A) [SST: KV38102100 (J-25803-01)], press-fit side oil seal so that its surface comes face-to-face with the end surface of the gear
carrier.
CAUTION:
-
Never reuse oil seal.
-
When installing, never incline oil seal.
3. Install the front final drive assembly on vehicle.
4. Install the front drive shaft. Refer to See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and