G20 L4-2.0L (SR20DE) (1992)
Drive Belt: Technical Service Bulletins
Poly Groove Belt - Installation & Alignment
Models:
All Vehicles
Date:
December 11, 1992
Classification:
EM92-006
Section:
Engine Mechanical
Reference
TECHNICAL BULLETIN ITB92-064
POLY-GROOVE BELT INSTALLATION/ALIGNMENT
APPLIED MODEL:
All Infinti models with poly-groove belt
SERVICE INFORMATION
When replacing or reinstalling any poly-groove belt, care must be taken to ensure that all of the poly-groove belts are properly aligned on the pulleys.
Before setting the belt tension, visually check to see that the belt is properly seated. The grooved belt must not ride on the inside or outside rim of the
pulley, because rapid wear or deterioration of the belt may result.
When installing a new poly-groove belt or replacing a used one, use the following procedure:
1.
Install the belt and set the belt tension.
2.
Start the engine and let it run for approximately 30 seconds. Switch engine off.
3.
Check belt tension and reset as needed.