A/T Controls - Shift Issues/Multiple DTC's Set
5. If this bulletin applies and you have performed TCM reprogramming; when reprogramming is complete the screen in Figure 2 displays.
6. Erase DTCs in all systems.
^ During TCM reprogramming DTCs will set in several systems and must be erased before ECM reprogramming.
7. Go to ECM Reprogramming below.
ECM Reprogramming
^ Make sure to erase DTCs from all Systems.
^ If your not familiar with the reprogramming procedure refer to "CONSULT-III (C-III) ECM Reprogramming"
1. Restart the C-III session by selecting the Home icon in the upper left corner of the screen.