G35 Coupe V6-3.5L (VQ35DE) (2003)
29.
After about one minute has passed, check the vehicle's battery voltage reading on the CONSULT-II screen (see Figure 5).
NOTE:
The vehicle's battery voltage is called "Charger Input".
A.
If the vehicle's battery charge ("Charger Input") is less than 12.0 volts:
^
Press "BACK" (2x) to go back to the main menu
^
Charge the battery properly/replace it before proceeding with TCM Reprogramming
OR
^
Trickle charge the battery during the reprogramming procedure
B.
If the vehicle's battery charge ("Charger Input") is more than 12.0 volts, proceed with the following step.
CAUTION:
Do not attempt TCM Reprogramming if the vehicle battery voltage is below the specified voltage. Permanent TCM damage can occur if the
battery does not maintain the minimum voltage during the TCM Reprogramming.
Step 3: TCM Reprogramming
30.
Turn the vehicle's ignition switch "OFF" and CONSULT-II off.
31.
Remove the Diagnostics (red/white) card from slot A of CONSULT-II and install the ECU Reprogramming card (orange) into slot A.
CAUTION:
Do not use slot B (bottom slot).
32.
Make sure the DLC-II cable is firmly plugged into the vehicle harness (see CAUTION below).