infiniti Workshop Repair Guides

Infiniti Workshop Service and Repair Manuals

Fluid Pan, A/T > < Fluid - A/T|Capacity Specifications|Page 8716
Page 1
background image

Fluid - A/T: Service and Repair

Changing A/T Fluid

NOTE: Use only A/T fluid level gauge with adapter: Special Service Tool No. J45475 and J45475-1

1. Warm up A/T fluid.
2. Stop engine.
3. Remove the oil charging pipe cap.
4. Drain A/T fluid from drain plug and refill with new A/T fluid. Always refill same volume with drained fluid.

-

To replace the A/T fluid, pour in new oil at the charging pipe with the engine idling and at the same time drain the old oil from the radiator
cooler hose return side.

-

When the color of the oil coming out is about the same as the color of the new oil, the replacement is complete. The amount of new
transmission fluid to use should be 30 to 50% of the stipulated amount.

A/T fluid: .....................................................................................................................................................................................  Nissan Matic Fluid J
Fluid capacity: ..............................................................................................................................................  10.3 liters (10-7/8 US qt. 9-1/8 Imp qt)

CAUTION: Use only Nissan Genuine ATF Matic Fluid J. Do not mix with other fluid.

Using automatic transmission fluid other than Nissan Genuine ATF Matic Fluid J will cause deterioration in driveability and automatic
transmission durability, and may damage the automatic transmission, which is not covered by the warranty.

Drain plug:  .........................................................................................................................................  29 - 39 Nm (3.0 - 4.0 kgf-cm, 22 - 29 ft. lbs.)

5. Run engine at idle speed for 5 minutes.
6. Check fluid level and condition. If fluid is still dirty, repeat step 2. through 5.
7. Make sure A/T fluid level gauge with adapter is removed then install the oil charging pipe cap.

Cap bolt: ....................................................................................................................................  4.4 - 5.8 Nm (0.45 - 0.59 kgf-cm, 39 - 51 inch lbs.)

Fluid Pan, A/T > < Fluid - A/T|Capacity Specifications|Page 8716