G35 Sedan V6-3.5L (VQ35HR) (2008)
/Page-637004.png)
b. Remove fuel injector from fuel tube by pulling straight.
CAUTION:
^
Be careful with remaining fuel that may go out from fuel tube.
^
Be careful not to damage injector nozzles during removal.
^
Never bump or drop fuel injector.
^
Never disassemble fuel injector.
12. Remove fuel sub-tube and fuel damper, if necessary.
INSTALLATION
1. Install fuel damper (4) as follows:
a. Install new O-ring (2) to fuel tube (1) as shown. When handling new O-ring, be careful of the following caution:
CAUTION:
^
Handle O-ring with bare hands. Never wear gloves.
^
Lubricate O-ring with new engine oil.
^
Never clean O-ring with solvent.
^
Check that O-ring and its mating part are free of foreign material.
^
When installing O-ring, be careful not to scratch it with tool or fingernails. Also be careful not to twist or stretch O-ring. If O-ring
was stretched while it was being attached, never insert it quickly into fuel tube.
^
Insert new O-ring straight into fuel tube. Never twist it.
b. Install spacer (3) to fuel damper.
c. Insert fuel damper straight into fuel tube.
CAUTION:
^
Insert straight, making sure that the axis is lined up.
^
Never pressure-fit with excessive force.
Reference value: 130 N (13.3 kg, 29.2 lb)
^
Insert fuel damper until (B) is touching (A) of fuel tube.
d. Tighten bolts evenly in turn.
^
After tightening bolts, check that there is no gap between fuel damper cap (5) and fuel tube.
2. Install fuel sub-tube.
^
When handling new O-rings, be careful of the following caution:
CAUTION:
^
Handle O-ring with bare hands. Never wear gloves.
^
Lubricate O-ring with new engine oil.
^
Never clean O-ring with solvent.
^
Check that O-ring and its mating part are free of foreign material.
