G35 Sedan V6-3.5L (VQ35HR) (2008)
/Page-637005.png)
^
When installing O-ring, be careful not to scratch it with tool or fingernails. Also be careful not to twist or stretch O-ring. If O-ring was
stretched while it was being attached, never insert it quickly into fuel tube.
^
Insert new O-ring straight into fuel tube. Never decenter or twist it.
^
Insert fuel sub-tube straight into fuel tube.
^
Tighten mounting bolts evenly in turn.
^
After tightening mounting bolts, check that there is no gap between flange and fuel tube.
3. Install new O-rings to fuel injector, paying attention to the following.
CAUTION:
^
Upper and lower O-ring are different. Be careful not to confuse them.
Fuel tube side: Black
Nozzle side: Green
^
Handle O-ring with bare hands. Never wear gloves.
^
Lubricate O-ring with new engine oil.
^
Never clean O-ring with solvent.
^
Check that O-ring and its mating part are free of foreign material.
^
When installing O-ring, be careful not to scratch it with tool or fingernails. Also be careful not to twist or stretch O-ring. If O-ring
was stretched while it was being attached, never insert it quickly into fuel tube.
^
Insert O-ring straight into fuel injector. Never decenter or twist it.
4. Install fuel injector to fuel tube as follows:
2: O-ring (Black)
4: O-ring (Green)
a. Insert clip (3) into clip mounting groove (D) on fuel injector (5).
CAUTION:
^
Never reuse clip. Replace it with a new one.
^
Be careful to keep clip from interfering with O-ring. If interference occurs, replace O-ring.
b. Insert fuel injector into fuel tube (1) with clip attached.
^
Insert it while matching it to the axial center.
^
Insert fuel injector so that protrusion (A) of fuel tube matches cutout (B) of clip.
^
Check that fuel tube flange (E) is securely fixed in flange fixing groove (C) on clip.
c. Check that installation is complete by checking that fuel injector does not rotate or come off.
^
Check that protrusions of fuel injectors are aligned with cutouts of clips after installation.
5. Install fuel tube and fuel injector assembly to intake manifold.
CAUTION:
Be careful not to let tip of injector nozzle come in contact with other parts.
